• Skip to primary navigation
  • Skip to main content
  • Skip to primary sidebar
  • Skip to footer
  • Home
  • Breaking News
    • Industry News
  • Gun Reviews
  • Gear Reviews
  • Ballistics
  • Concealed Carry
    • Defensive Gun
  • 2A

Gunners Den

  • Ammo
  • Rifles
    • ar-15
    • SKS
    • M1 Garand
    • M1 Carbine
    • Mini
  • Shotguns
  • Handguns
  • Hunting
  • Reloading
  • Trade Shows
  • Gun Info

Kel Tec CMR 30 Review

April 25, 2021 By Terry Nelson

Kel Tec CMR 30
The CMR-30 with stock collapsed and sights folded down

Kel-Tec CMR-30 Review

If you like compact and maneuverable carbines in the hot 22 WMR rimfire cartridge then the Kel-Tec CMR-30 is a great option. Kel-Tec introduced the CMR in .22 WMR in early 2015 adding another player to their lineup of lightweight, compact rifles.

There’s a lot to love about this little gun, and if you combine it with the Kel-Tec PMR-30 pistol (same caliber and magazines) you would have a dynamite package for hunting, survival, and target shooting.

This carbine barrel is 16.1 inches with a 1 in 16-inch twist. With the stock fully extended, the overall length is 30.6 inches. Thanks to a mostly aluminum construction, it’s very lightweight at 3.8 pounds, unloaded.

Sling mounts like this on left and right

CMR 30 Features:

This gun is loaded with a wide range of usable features right out of the box. Examining this little carbine overall you will find:

  • Metal sling loops on either side of the buttstock. Admittedly, they’re small but that’s a trait that can be compensated for by using a bit of paracord to accommodate larger sling hardware connecting points.
  • Adjustable stock. Kel-Tec calls it a four-position stock, but that doesn’t include the fully collapsed position, which shortens the gun to a very portable 22.7 inches. The ambidextrous adjustment lever is located just under the top front of the trigger guard. Operation in my experience has been silent and very smooth.
  • Ambidextrous safety. Several folks that shot in testing the CMR are southpaws and all found the thumb-operated lever convenient.
  • Ambi magazine release. Like most other things on this rifle, the mag release is ambi-friendly. Its location at the rear lower edge of the mag well takes a little getting used to however.
  • A textured pistol grip that compliments this gun’s pack-ability with its narrow, flat profile. The signature Kel-Tec texture makes keeping a solid grip and shoulder mount easy.
  • An oversize trigger guard allows for safe operation even with gloved hands.
  • Flip-up Magpul rear sight, with aperture that’s adjustable for windage. This (along with its mate up front) is a surprisingly high-end attachment. Regardless of the reason for putting better sights on the CMR-30 than on other Kel-Tec carbines they did right by the consumer with this choice.
  • Flip-up Magpul front post. This setup is great for keeping the gun compact as optics can clear the sights without being mounted extra-high. The sights can thus co-witness with many optic setups.
  • More Pictatinny rail than you’ll ever use runs the length of the receiver, top and bottom. You can add more stuff than you probably need!
  • Ambidextrous bolt operation, with a charging handle big enough to grab onto and operate quickly to clear a malfunction while keeping the gun shouldered. It’s also there to simply lock the bolt back, though doing that without breaking the firing position would take more work than I’ve put into this gun so far. The lock-back lever isn’t ambi; it’s on the left side only. At first glance it appears the charging handles may reciprocate during firing, endangering fingers. They don’t—they’re only for manually pulling the bolt rearward.
  • Threaded muzzle, with a good checkered steel cap, allows for quick installation of a suppressor or flash hider. The cap keeps the threads clean and the barrel streamlined without an accessory.
CMR-30 with Gemtech Suppresor

Kel Tec CMR Trigger

The CMR trigger has a bit of take-up but isn’t heavy or grainy, and the reset is palpable without being match-grade sensitive. Kel-Tec says the weight range is three to five pounds and it’s not adjustable.

CMR’s Accuracy and ammo

We shot the CMR with a variety of setups from prone, kneeling, and standing positions. We shot both with and without a bipod, with and without a Gemtech Outback 2 model suppressor, with the stock sights and with a red dot optic and found the accuracy was more than acceptable.

Especially considering a magnified optic was NOT utilized for a detailed accuracy test.

View through Magpul flip-up sights on the CMR

Ammo types during the trial include CCI TNT Green (lead-free) 30 grain, CCI Maxi-Mag 40 grain, and Hornady Critical Defense 45 grain. All achieved one to one-and-a-half-inch groups at 25 yards, with the TNT Green forming the tightest group of less than an inch.

This is not to pass negative judgement on the other loads, as improvised rests used in the prone position, wind and shooter error surely had some effect, as they usually do.

A nice package the CMR-30 along with the PRM-30

Kel Tec CMR Magazines

The owner’s manual provides rather sternly-worded instructions about loading the magazines, and they’re not kidding. Loading the 30-round mag is the only thing inconvenient about operating this gun.

Ammo must be loaded from the front of the magazine while sliding the round towards the rear wall of the magazine. The manual recommends tapping the flat back side of the mag on a flat wooden surface every 5-10 rounds.

The spring is quite tight and much pressure is required to load the last ten rounds. The rounds also tend, at any stage of loading, to get a little off kilter in their double-stack configuration.

The four misfeeds experienced during the 125-round test (a three percent failure rate) can probably be attributed to a slightly displaced round near the top of a full magazine. Once you become accustomed to the magazine loading procedure it’s not that big a deal.

The magazine drops easily from the mag well upon release. This allows one to run speed or tactical reloads without hassle.

The CMR 30 and the PMR 30 both take the same magazines, found here.

Kel Tec CMR 30 Takedown

Disassembling the CMR-30 is a straightforward process, if unusual in comparison to most common semi-autos. A small pin located on the frame and above the trigger must be pushed through with an improvised pointy object.

The grip/trigger assembly separate as one unit, along with the stock, and barrel/bolt assembly which can be separated for cleaning. It’s not intuitive, but once done, it’s easy to repeat.

CMR-30 with stock collapsed and ACOG optic

Final thoughts on the CMR

Fitted with a magnifying optic, zeroed for the shooter’s ammo of choice, the Kel-Tec CMR-30 is a highly portable, dependable, and accurate tool for a variety of applications out to at least 100 yards and probably beyond. For shooters whose visual acuity is good, the same is true for using the rifle with its stock sights.

What’s even more appealing is that the CMR-30 companion gun, the Kel-Tec PMR-30, a full-size pistol of the same caliber and the magazines are the same for both. 

Finally, Kel-Tec provides a full-color, highly detailed owner’s manual. It’s a nice gesture in an age when most manufacturers are issuing dull, generic manuals that drive us to YouTube when it’s time to clean the firearm.

Both the Kel Tec CMR and the PMR-30 seem to enjoy a continued high demand. Current retail pricing for the CMR-30 ranges from $450 to $550.

Find our 22 Magnum ballistics chart on the page that link brings you to.

Filed Under: Gun Reviews, Gear Reviews Tagged With: cmr 30, gun review, Kel Tec, rifle, second amendment, Test and Evaluation

About Terry Nelson

Terry is a 30-year veteran of law enforcement including having served as a state game warden. A lifelong hunter, angler, guide, and firearms enthusiast, he currently provides training for law enforcement, security and civilians through his own company, Firearms Training Institute. In the fall and winter months you will find Terry hunting or guiding hunters for big game across the state of New Mexico.

Primary Sidebar

Most Popular Posts

Best AR-15 Manufacturers

When Will Ammunition Prices Go Down?

Handgun Ballistics Chart

Rifle Ballistics Chart

Muzzle Brake vs Comp vs Flash Hider

12 Best 9mm Handguns

45-70 Ballistics, History, Info

Best Optics Ready Pistols

Cheap Bulk 223 Ammo

Follow Us

YouTube

Facebook

Footer

Disclosure

Privacy Policy

About Us

Contact Us

Advertise

Contributors

Sitemap

Copyright © 2023 · GunnersDen.com ~ As a participant in the Amazon Associates program and other affiliate services, I may earn a small amount of money if you buy something after clicking on a link. It in no way increases the amount you pay and helps us stay in business. Please know that we only recommend products we trust and have used ourselves.